Work Methods for Sound Absorption (Internal Filling Material)
Brings about sound-proofing
effect between floors. Demanded recently for
this product is high.
Ink Lining(450X360mm) and hole drilling
: to set free-pins
Fix free caps and install T-MAX(leveling
work) - Lengths of free caps
18,30,48,68mm
Attach gypsum boards and perform finishing
work(using screws or tackpins)
Curing
Fix M-bars, T-bars and T&H bars.
Install T-MAX Put T-MAX over
the installed bars or insert between bars.
Use 50mm T-MAX Standard Type
Install the ceiling material specified
in the design.
Work Methods for building Sound Absorption
In sound sensitive areas such
as auditoriums, gyms, broadcast studios, music
rehearsal halls and machine rooms, these work
methods trap various noises and help convey
precise ‘sound’.
Ink lining work Measure the
surface of the walls and the ceilings
Must follow the acoustic design
Fix lower moldings (joiners)
Install T-MAX
Use
25T 60K or 50T 40K T-MAX
T-MAX FABRIC: A T-MAX product with
fire retardant fabric on one side.
Suitable for areas where visual
design is important. Double-Layer
Board : A T-MAX
product processed with finishing
material on one side. Does not require
separate finishing material. (Machine
rooms and HVAC rooms)
Fix upper moldings (joiners).
Curing
: Possible
to create diversified designs
Ink lining - Measure the surface
accurately
Production
of sound absorption panels
Use 25 mm or 50 mm T-MAX for large-scale
areas such as auditoriums. 10 mm
T-BOARD may be used for homes.
Select finishing material suitable
for the atmosphere the designer
wishes to create.
These can be metallic (aluminum)
boards, plywood boards, particle
boards such as MDF, fabric, etc.
Install sound absorption panels.
Fix
squared timber (5~8 mm) following
the ink lines
Install T-BOARD over the squared
timber. (to produce a layer of air
between the wall surface and the
panels)
Curing
Work Methods for Thermal Insulation
Ink lining work
Fix double brackets - using T2 bonding
glue
Install T-MAX and fix caps
Apply gypsum bonding glue and attach gypsum
boards
Ink lining work
Install Furring Strip (Styrofoam) - using
T2 bonding glue.
Install T-MAX (330×1800 mm).
Apply gypsum bonding glue on the Furring
Strip and finish with gypsum boards.
Ink lining work (314×450)
Fix free cap pins (6 mm wide).
Install T-MAX.
Fix Free Caps leveling work (using leveling
rule)
Attach gypsum boards and perform finishing
work (Using Gypsum Screw)
Install upper and lower runners.
Fix studs.
Attach gypsum boards on one side.
Install T-MAX.
Attach gypsum boards on the finishing
side.
Finish the joints (with joint tape and/or
compound).
Ink Lining(450X360mm) and hole drilling
: to set free-pins
